* Méthode d’installation d’un serveur PTP sous linux :

* Installation « linuxptp ptpd » :

apt-get install linuxptp ethtool ptpd

* Configuration :

pico /etc/ptpd.conf

; /etc/ptpd.conf

; ==============================================================================

; This is a recommended configuration for a PTPv2 slave

; For a full list of options run ptpd2 -H or see the documentation and man pages

; ==============================================================================

; interface has to be specified

ptpengine:interface=eth1

; PTP domain

ptpengine:domain=3

; available presets are slaveonly, masteronly and masterslave (full IEEE 1588 implementation)

ptpengine:preset=masterslave

; multicast for both sync and delay requests – use hybrid for unicast delay requests

ptpengine:ip_mode=multicast

; when enabled, instead of sockets, libpcap is used to receive (sniff) and send (inject) packets.

; on low latency hardware such as 10GE NICs this can provide results close to hardware-assisted PTP

ptpengine:use_libpcap=y

; go into panic mode for 10 minutes instead of resetting the clock

ptpengine:panic_mode=y

ptpengine:panic_mode_duration=10

; uncomment this to enable outlier filters

;ptpengine:sync_outlier_filter_enable=y

;ptpengine:delay_outlier_filter_enable=y

; store observed drift in a file

clock:drift_handling=file

; update online statistics every 5 seconds

;global:statistics_update_interval=30

; wait 5 statistics intervals for one-way delay to stabilise

;ptpengine:calibration_delay=5

; log file, event log only. if timing statistics are needed, see statistics_file

global:log_file=/var/log/ptpd2.log

; log file up to 5M

global:log_file_max_size=5000

; rotate logs up to 5 files

global:log_file_max_files=5

; status file providing an overview of ptpd’s operation and statistics

global:log_status=y

; required if ip_mode is set to hybrid

;ptpengine:log_delayreq_interval=0

; uncomment this to log a timing log like in previous ptpd versions

;global:statistics_file=/var/log/ptpd2.stats

; on multi-core systems it is recommended to bind ptpd to a single core

;global:cpuaffinity_cpucore=0

; use DSCP 46 for expedited forwarding over ipv4 networks

ptpengine:ip_dscp=46

; always keep a new line in the end